|
RACK-A-TIERS
Wire Dispensers |
|
|
RACK-A-TIERS
Wire Dispenser
As a wire dispenser only, RACK-A-TIERS
are hard to beat but they have many other uses. It's a good thing
they're tough because they get a lot of use and you'll have them for
a long time. No moving parts, won't rust, rot, scratch your trunk,
bash the doorframe, and they float. Nice and compact, RACK-A-TIERS
earn their place in your truck. (sold in pairs) |
|
Hooker Pipe Wrench Adapter |
|
|
Hooker Pipe
Wrench Adapter
Every RACK-A-TIER
needs a
HOOKER! - RACK-A-TIERS
have always had a "pipe vise" capability with the 'V' notches. They
set out to improve this function and succeeded beyond expectation. A
set of RACK-A-TIERS
with a HOOKER pipe wrench adapter can stand in for a tripod or bench mounted
pipe vise plus it's faster and easier to use. The HOOKER is far
lighter, less expensive and fits all RACK-A-TIERS. |
|
Rack 'N
Roller Wire Dispenser |
|
|
Rack
'N
Roller Wire Dispenser
Wire spools run on spring-loaded
rollers, - no axle - Spools can be loaded one at a time without
disturbing the others. - If you use a lot of THHN, this is your
unit, especially for a service truck. Easy to tow around, handles
for lifting AND it's a piece of cake to change each roll out. It
stores and protects your wire spools when not in use. - No axles or
loose parts. Rugged Construction - 32" long - holds 4 - 5 rolls of
THHN (10, 12, 14 AWG) |
|
E-Z
Roll Wheeled Wire Rack |
|
|
E-Z Roll
Wheeled Wire Dispenser
Most wheeled
wire dispensers are too big for your truck and they only hold little
wire spools. The E-Z Roll Wire Rack knocks down in seconds
and handles reels to 18 inches. (150 lb. Load Tested). Use a conduit
bender or scrap of 1" EMT (not included) for an axle/handle. The E-Z
Roll is big enough to handle 1000' rolls of Romex., but small enough
to fit in a Job Box. Simple, Effective, Rigid Steel
Construction and Light-weight Design. |
|
Thomas Wheeler Coil Spinner / Wire Spool |
|
|
Thomas Wheeler
Wire Spool
This easy-to-hang wire
dispenser allows fast, twist-free Romex, MC cable or flex pulling.
- Most coil dispensers are too big,
cumbersome and expensive. Not this one. The Thomas Wheeler knocks
down (folds down flat) and sets up in seconds, hangs on 2x4, in the
trusses, above tee bar or on a ladder. Light, simple, rugged and it
really works. A great value! |
|
Wire Tub - Wire Rewinder AND Dispenser |
|
|
Wire Tub - Wire
Dispenser and Rewinder
All coil dispensers dispense but this one
REWINDS
wire as well. Over-runs can be wound
back, old wire salvaged and re-installed. And it's fast. No hanging
or mounting, the WIRE TUB
just sits on the floor. Handles Flex, Romex, MC, etc. Same tough
plastic as RACK-A-TIERS.
Awesome!
- Big 24" diameter capacity. |
|
REEL-END - Wire Spool Repair |
|
|
REEL-END - Wire
Spool Repair
How many broken spools are in your shop?
A few? A bunch? There's gold in them thar rolls but how do
you get at it? Fix them with the Reel End. Pays for itself with the
first roll saved and it's reusable again and again. The Reel End
fits plastic spools #10 through #18 gauge. A real money maker.
"Who says you can't
put those pieces back together?" |
|
Pull-Rite 'Wire Brake' |
|
|
Pull-Rite 'Wire
Brake'
Full
new rolls wound to the rim?
- No longer a problem. Jerky pull with lots of stopping?
- No more "bird's nesting". Just want one or two
conductors from a group? - That's all that spins.
One man pulls? - Easy, and the PULL-RITE is easy to
install!. It clips on each roll in seconds and fits standard #12 and
#14 wire spools. |
|
BEND ALL Cable Bender |
|
|
BEND-ALL Cable
Bender
Finally, the Amazing
Knuckle Saver from Rack-A-Tiers -
Ever give a meter
base a knuckle sandwich? Too
bad it was your own. Next time, defend yourself with the Bend All.
Perfectly sized for 4/0, it takes the pain out of 200 amp services
or sub feeders. The conductors like it too. The Bend All makes micro
adjustable bends without brutalizing the wire. Fits #3 to 350 MCM
conductors. Machined from 6061 Aircraft Aluminum - Fits on a
standard 1/2" ratchet. |
|
Snatch Strap Wire Puller |
|
|
Snatch Strap
Wire Puller
Time is money
and when you think about it, a lot of time is spent stripping,
taping and untaping wire for fishtape pulls. The SNATCH STRAP
gives you back this time. Because it staggers the wire, you can pull
more conductors with less effort. Because SNATCH STRAPS can
be daisy chained, you can easily drop wire groups at boxes along the
pull. Brilliant! - Package
includes 3 Snatch Straps. |
|
Conduit Level - Torpedo Level with Laser |
|
|
Laser
Conduit Torpedo Level
Laser Torpedo Levels don’t work too well if they keep falling off
your pipe. Designed for metallic pipe, the Conduit Level has
powerful magnets and a
concave base to align the Laser Level with the pipe.
Accurate to ± ¼ inch @ 100 feet.
Three vials (0°, 45° and 90°) -
Anodized aluminum construction -
Can be attached to any compatible tripod.
- Free carrying case and batteries -
This is a nice Level. |
|
Self-Leveling Vertical Laser Plumb Bob |
|
|
Laser
Plumb Bob
Looking
for a better way to lay out complex ceilings and high bays?
- Tired of trying to measure ceiling
work from the top of a ladder? -
The RACK-A-TIERS®
Laser Plumb Bob enables you to lay out overhead work on the ground
and then quickly transfer the measurements to the ceiling.
Factory
aligned laser module calibrated to precise 0.15° accuracy
- Magnetic
damping for quick stabilization. |
|
Croc's Needle-Nosed Wire Strippers |
|
|
Croc's Wire Strippers
Croc's™! What a beautiful stripper. -
Dual action sheath stripper, crimper,
oversized cutters - and more!
-
Romex sheath
stripper at the "nose" where it is easier to use inside boxes
-
Strips
conductor sizes from #10 down to #22 AWG (for telephone wire)
-
Large cutting
blades for easy general purpose cuts
|
|
Head-LITE Hat - the Hands-Free LED Flashlight |
>>
more info |
Head-LITE
Hat
The Head Lite Hat is great for
jogging, hiking, walking the dog, etc. Heck, some guys are even
using them for work. They're the ones who are tired of holding a
flashlight in their teeth or under their chin when working in tight
places, attics, crawl spaces... All the benefits of a flashlight,
and a hat in one. Neat!
Comes in
Black
or Camouflage |
|
Ladder Sack |
|
|
Ladder Sack
The Ladder Sack fits
in the wasted space of your stepladder and safely holds just about
everything that's presently falling off the top. This includes light
bulbs, fluorescent tubes and expensive tools. Provides an
alternative to carrying, or bending for tools and parts normally
left on the floor! Opens and closes automatically with the
ladder and sides close to help hold the cargo in. This thing's
ingenious. Fits all A-Frame Ladders, installs in seconds.
Buy 3 and $ave! |
|
Exploding Garbage Can Collapsible Trash Container |
|
|
Exploding
Garbage Can Collapsible Trash Container
Clean
up your reputation with your own trash can. The Exploding Garbage
Can will dazzle your customers, especially if you use it! Pops up
and folds flat... ready when needed. Featuring an internal
support spring that "Springs into Action" -
Heavy Duty, Tear Resistant Polytuf Fabric
19" x 24" (open) 1½" x 24" (collapsed) |
|
DRILLER'S Dust Bowl |
|
|
DRILLER'S Dust
Bowl
You may enjoy a face full of drywall dust
but your customers might not! The
flexible DRILLER'S Dust Bowl compresses and traps dust and
debris as you drill. It fits your drill and holesaw without
any adjustments. Put an end to 'unprotected holesawing' Fits
Hole-Saws up to 8" diameter |
|
PlugGrip and Tester |
|
|
Plug Grip and
Tester
Never hold an electrical
outlet with your fingers again!
For duplex outlet installations, hold the PlugGrip instead of
the outlet! Insert the PlugGrip into the outlet before wiring to
provide greater control over stiff electrical wires. Separate feed
power warning lights will indicate power to receptacles. Works great
for remodeling projects and speeds up new installations! Handy for
leveling plugs. |
|
|
|
|
Order online: Add your item to your shopping cart and
submit your order online*.
Order
offline: Add your item to your shopping cart and print an
offline order form*. Mail or fax your order to us 
2008/2005
